Foxwell NT530 Mercedes-Benz

Foxwell NT530 Mercedes diagnostic device

The Foxwell NT530 Mercedes-Benz diagnostic device allows you to read Mercedes at a high level. You are not limited to just reading the engine management with this device. The NT530 for Mercedes goes much further than that. It can read every system present in the Mercedes, clear error codes and view live data from sensors. Many Mercedes models can be read with the NT530, but not every model. To be sure that the Mercedes can be read with the Foxwell NT530, please refer to the function list at the bottom of the page. This describes exactly which system of which model can be accessed.

Functionaliteiten NT530 Mercedes

In addition to the standard OBD2 functionality, the NT530 also has features on board that until now were reserved only for expensive diagnostic equipment and interfaces. Below is a summary of the capabilities.

• Reading generic OBD2 error codes
• Display live data in almost all modules
• Read out Mercedes-Benz-specific error codes
• Controlling actuators
• Making adjustments to the car software
• Programming of modules in different ECUs
• Support for EPB/SBC
• Learn the throttle body
• Service interval reset
• Reset oil interval
• Reset adaptation values
• Generate particulate filter
• Adjust headlights
• Calibration of steering angle sensor
• Teaching of new parts
• Teaching of replaced parts
• Opening and closing of electronic calipers

Function lists

In the Mercedes function lists at downloads (PDF) you will find all Mercedes models and modules that can be read with the NT530. At the bottom of the file you will also find the special operations the device can perform on certain models. Before ordering the device, we recommend that you check carefully whether the features you want are present and whether the Mercedes model is supported.